Specify Presentation Settings

Through the Presentation page, you can specify the settings for the graphics file.

To specify the presentation settings:

1. Click the Models tab.

2. On the Presentation page, do one or more of the following based on your requirements:

   

   • Click Get settings from graphical view if you want to reuse the settings provided in View > Settings > Graphical View of AVEVA™ E3D Design.All the settings defined in the Graphical View dialog box of AVEVA™ E3D Design are loaded in the Presentation page of AVEVA™ Gateway for Unified Engineering. You can then modify the settings based on your requirement.

   • Select or clear the check boxes for Centerlines, Holes, Plines and Tubes depending on whether you want to add these components in the graphics files.

   • Modify the levels for Pipe, Nozzle, Hvac, Cable, Structure, and Other depending on how many levels of these components you want to be included in the graphics files.

   • Turn the Insulation translucency and Obstruction translucency On or Off depending on whether you want to view the insulation/obstruction translucency in the generated output.

   • Adjust the Density factor slider according to the required density.

     Note: The density factor setting is applicable only for XGL/ZGL file. The setting is ignored in RVM files.