Setting up isolation points

• Add isolation points to isolation list

Add isolation points to the list. There are several ways to add isolation points. You can add Isolation points by searching for tags.

• Adding isolation points from schematics view

Add isolation points from tags in the schematic.

• Create isolation points manually

Optionally, you can plot new isolation points on the schematic drawing.

• Change maintenance position on points

Change the Maintenance position, if needed.

• Add system locks to isolation points

• Add personal locks to isolation points

Add a system lock or personal lock to an isolation point, if needed. This indicates that the physical point is locked.

• Process the isolation list workflow

Process the status of the isolation list.

• Sign for Isolated on an isolation point

Sign off on each of the isolation points in the isolation list. Each isolated point must be signed.

• Sign for Reset on an isolation point

Reset the isolation points to their starting positions. When work is complete, the points need to be reset to original position.

• Sign for Test on an isolation point

If required, test the resetting of isolation points to their starting positions.

• Process the isolation list workflow

When all points have been reset and tested, close the list. Close the isolation list by processing it to Closed status.