Tested GE Hardware
- Last UpdatedJul 06, 2020
- 1 minute read
The GESRTP Communication Driver operates only with a standard network interface card in the computer on which it is installed. The GE PLCs must include Ethernet modules or controllers (CPUs) with built-in Ethernet ports.
The following table lists the hardware that has been tested with the GESRTP Communication Driver.
|
Device |
Description |
Hardware and Firmware |
|---|---|---|
|
Series 90-30 PLC |
Controller |
TCP/IP Ethernet Interface module (catalog number IC693CMM321) OR Controller (CPU) with built-in 10/100Mbs Ethernet port (catalog number IC693CPU364/ IC693CPU372) |
|
Series 90-70 PLC |
Controller |
MMS-Ethernet Controller module (catalog number IC697CMM741/IC697CMM742) You must properly configure and download device IC697CMM741 using the Series 90-70 Ethernet TCP/IP software (catalog number IC651ENS042). |
|
Versamax |
Controller |
CPU with Ethernet port (catalog number IC200CPUE05) |
|
VersamaxMicro PLC |
Controller |
Ethernet Interface, a Bridge from RS-232 or RS-485 Serial to Ethernet 10 BaseT (catalog number IC200SET001) |
|
VersamaxNano PLC |
||
|
Rx7i PACSystems |
Controller |
TCP/IP Ethernet Interface module (catalog number IC698ETM001) OR Controller (CPU) with Embedded 10/100Mbs Ethernet port (catalog number IC698CPE010/ IC698CPE020) |
|
Rx3i PACSystems |
Controller |
TCP/IP Ethernet Interface module (catalog number IC695ETM001) OR Controller (CPU) with Embedded 10/100Mbs Ethernet port (catalog number IC695CPE305) |