Discharge the Equipment

The final step in the Phases pane is to add the discharge (free up) the equipment.

To discharge the mixers

• In the Unit Procedures pane, select the Discharge – Mixers block.

  

To add the Transfer – Mix Hold block in the Phases pane

1. In the Phases pane, click just below the Discharge – Mixers block.

2. Click the Add Phase icon.

3. On the Add Phases dialog box, check to make sure that the Type is Transfer.

   

4. Select Mix_Hold – Transfer and click OK.

To configure the Transfer – Mix Hold block

5. Double click the Transfer – Mix Hold block.

6. On the Phase Properties – Transfer dialog box, select the Parameters tab.

7. Click ID.

8. On the Outputs dialog box, select CB100, and then click OK.

9. Accept the Value 100 and click Change.

10. Click Close.

    The following figure shows the completed Phases pane for the Discharge operation.