Properties

The following properties apply to the BatchGuiConfig control.

Host1

This selection sets this property to the host name of the AVEVA Batch Management Server. In a redundant server architecture, this is the host name of the Primary Batch Server.

Host2

This property is only used with redundant server architectures. It sets this property to the host name of the Redundant Batch Server.

AutoInit

When set to 1 (or checked on the property page) this property initializes the connection to the Batch Server automatically when the control is loaded in a running application, or the application is switched from design mode to run mode (such as WindowMaker to WindowViewer).

Unit

This is a string set to the unit to focus on when running in Unit-Centric mode. If this property is left blank, the Batch GUI controls run in Batch-Centric mode.

MessageBoxes

This property is a true or false Boolean type. True specifies that error message boxes should be shown. False turns off the error message boxes. The default value of MessageBoxes property is true.

ServerConnected

This property is available only at run time (not available at design time). It is set to True (or a non-zero value) when there is an active connection to the Batch Server.

The following properties define the tcp/ip port definitions for the connection to the Batch Server. The port definitions are pre-defined with the default numbers used on the Batch Server. These must match the port definitions used on the Batch Server for communications to be successful. Only change these properties if you have changed the port definitions on the Batch Server because of a system conflict.

• PortBatchMngr

• PortEnvMngr

• PortInfoMngr

• PortRedMngr

• PortSecMngr

• PortUnilinkMngr