Resize embedded Industrial Graphics

After embedding an Industrial Graphic into an InTouch window, you can resize it with its handles or with the width and height value entry as you would with any other InTouch object.

However, if the Industrial Graphic contains at least one rotated element, you can only resize the Industrial Graphic proportionally.

You cannot resize the embedded Industrial Graphic smaller than its minimum size. The minimum size may be determined by the pen width of a contained element.

You can reset the embedded Industrial Graphic to its original size when it was created in the Industrial Graphic Editor.

Resize an embedded Industrial Graphic

1. Select the Industrial Graphic so that the handles appear.

2. Do one of the following:

   • Drag the one of the handles to resize the Industrial Graphic to the new size.

   • Enter width and height in the W and H boxes on the status bar.

Resize an embedded Industrial Graphic to its original size

• Right-click the embedded Industrial Graphic you want to change to its original size, point to Industrial Graphic, and then select Symbol - Original Size. The embedded Industrial Graphic is changed to its original size.