Enable Tag Viewer

You can configure the WindowViewer properties at design time to enable Tag Viewer to run. You can also configure the WindowViewer menu so that the Tag Viewer option is displayed in the Special menu.

After you modify these properties, you must restart WindowViewer for your changes to become effective, if WindowViewer is already open.

Enable Tag Viewer

1. Open WindowMaker.

2. On the File menu, point to Configure, and then select WindowViewer.

   The WindowViewer configuration screen appears.

3. Select the Preferences tab.

   

4. In the WindowViewer Startup area, select the Enable Tag Viewer check box so that you can start the Tag Viewer. This check box is not selected by default.

5. In the Minimum Access Level box, configure the security access level required to run the Tag Viewer application. The default value is 9999, and you can type any value between 0 and 9999.

   Note: If your access level is less than the minimum access level, you cannot start Tag Viewer at run time.

6. Select the Window tab.

   

7. In the Menus area, select the Tag Viewer check box to enable the Tag Viewer option in the Special menu of WindowViewer.

8. Select OK.

9. After you modify any of these parameters, you must restart WindowViewer to apply your changes.