Start a Network Application Development (NAD) application

Network Application Development (NAD) supports Operations Control connected experience. Note that for NAD to work in Operations Control connected experience, you must enable Operations Control connected experience on all nodes of your system.

Work with NAD application in Operations Control connected experience:

1. Launch NAD client.

   If you are launching NAD for the first time on this node and no other Operations Control product was launched and authenticated on the same node before, then you are prompted to authenticate with AVEVA Identity Manager on a web browser or embedded browser (based on the choice that you have made while configuring Authentication tab in System Management Server of the Configurator). If you have already launched and authenticated NAD on this node or launched and authenticated any other Operations Control product on the same node before, then you will be authenticated using Single Sign-On. For more information refer to Authenticate using AVEVA Identity Manager section.

2. Enter your email address that is registered with an CONNECT account to sign in to AVEVA Identity Manager and the respective password.

   Once you signed in successfully and if you have Edge or Supervisory subscription, Single Sign-On (SSO) will be used to sign in and the application runs. You will not have to enter the credentials again on subsequent logins.

   Note:

   - If the sign is successful and do not have valid entitlement then contact your administrator for valid entitlement. If the sign in is not successful, you will be prompted an error message. Contact your administrator for valid credentials.

   - If a machine gets disconnected, you will not be able to authenticate again and therefore you will not be able to run applications.