Enter and validate sample data

Use the Quality Execution use case details to input and verify quality sample values for the current work order. This panel is designed to ensure that all entries are accurate, complete, and within defined control limits.

Enter and validate sample data

1. Select a Quality task.

   The Quality Execution use case detail opens displaying the selected characteristic name and its target value. The characteristic and its target value are configured in MES Client.

2. Use the range bar to review the acceptable range for each characteristic:

   • Green: Within acceptable range (within LSV and USV).

   • Yellow: Nearing limit.

   • Red: Out of specification (outside of LRV and URV).

   • Lower Rejection Value (LRV): The minimum value below which a sample is automatically considered out of specification and rejected.

   • Lower Specification Value (LSV): The lower bound of the acceptable range. Values below this may be flagged as warnings or out of spec depending on severity.

   • Target: The ideal or expected value for the characteristic being measured. This is the central reference point for quality evaluation.

   • Upper Specification Value (USV): The upper bound of the acceptable range. Values above this may be flagged as warnings or out of spec depending on severity.

   • Upper Rejection Value (URV): The maximum value above which a sample is automatically considered out of specification and rejected.

3. In the Value field, enter numeric or categorical test results for each characteristic.

4. Use the Result field to interpret results.

   The Result is either auto-calculated or selected from predefined options based on the Value entered.

5. Select Add Row to enter additional sample values.

   Add Row is enabled if additional values are allowed by the sample size configuration.

6. Select Save to save the information. This ensures your entries are stored and available for further analysis.