Revisions Tab
- Last UpdatedOct 08, 2025
- 1 minute read
Use the functionality available from the Revisions tab to specify the settings for the Termination Diagrams/Enhanced Termination Report Drawings.
-
If the same revision details are to be applied to all the multiple sheets of a termination diagram, check the Single Revision Mark for all Drawing Sheets checkbox. If each termination diagram sheet is to have separate details, leave the checkbox unchecked.
-
Enter the maximum numbers of loop, termination, hookup, etc. revisions that are to be listed on drawings in the fields provided.
-
In the Name Captions section of the tab, specify which details are to be displayed for each drawing revision (for example, By, Checked, Approved) by checking the appropriate checkbox.
-
If the caption for a revision detail is to be other than the default caption, enter the required caption in the field provided. For example, if "Reviewed" is to be used instead of "Checked", enter "Reviewed" in the Caption field for the Checked caption.