Tag Wiring Check Report Preferences

Tag Wiring Check Report preferences can be set from the Preferences window.

To display this window

1. Select Preferences from the File menu.

   Note: In addition to the preferences described here, the default Enhanced Cable Block Diagram cable label symbol defined in Instrument Wiring Manager may be used on Wiring Check Reports instead of the normal symbol, depending on the Instrument Wiring Manager preferences for the Project.

   The General tab is used to specify how the Tag Wiring Check Report is displayed.

   

   The Cable/Wires tab is used to specify how the cable and wires will be displayed in the Tag Wiring Check Report.

   

   The Printing tab is used to set the default paper size, orientation and margins, the maximum number of terminals that can be displayed on each page and to add a header and footer to the pages.

   

   The Export tab is used to define the settings to be used when exporting the Tag Wiring Check Report to AutoCAD.

   

   Note: You must have AutoCAD installed on your workstation to export the Tag Wiring Check Report successfully.

2. You can revert the report references back to the default settings by clicking Use Default.

3. Click OK to save the changes and close the Preferences window, or click Cancel to close the Preferences window without saving any changes.

4. To commit the changes to the Tag Wiring Check Reports window, click Apply. A warning message is displayed informing you that applying the new settings will cause the diagram to reload.

   

5. Click Yes to continue, or No to terminate the process.