Define Device Internal Connections

To enable Wiring Manager to trace signal through a device, you should define its internal logical connections.

1. To define the device's internal logical connections, first save the new device and then select Edit.

   Wiring Manager does not allow the internal connections to be saved until terminals have first been saved to the database.

   Important: Changing the internal connections changes all the devices in the project that use the current device being edited.

2. Define internal connections as follows:

   1. Hold the Ctrl key down and click on a terminal.

   2. Select another terminal on the other side of the device in the same way.

   Selected terminals are highlighted in red.

3. Click + Internal Connection.

   A connection is then formed between the two terminals.

   Wiring Manager will indicate connections with black lines between them as in the example below:

   

4. To remove a connection, select the terminals at each end of the connection as described above, and click - Internal Connections.