Uploading Controls in the ICC

An Upload operation copies the values of all block parameters from the CP database to the Configurator Database. During this time, access to the ICC is disabled. Ideally, this operation should be performed in the plant before savealls are created for use in the simulator.

Upload is required for two reasons:

• Parameters have been changed through the Select or FoxSelect / BlockSelect screen

• An IC restore was performed from an IC that has different control parameters than those currently in the Configurator Database and you want to replace the Configurator Database parameters

To perform an Upload operation, complete the following steps:

1. Click MAINT on the ICC menu bar.

2. From the drop-down list, choose Upload.

3. After the upload is complete, exit the ICC by clicking EXIT on the ICC menu bar.