Use preselected volumes

You may select Refresh Table to load all available volumes from either of the following sources:

• Pre-selected volumes from within the AVEVA Point Cloud Manager Volumes Manager.

• Display sets saved under a project.

AVEVA Point Cloud Manager Volumes Manager import

To show volumes created in Point Cloud Manager in SmartPlant Review:

1. In AVEVA Point Cloud Manager, within the Volumes Manager, right-click on the Project Volumes/Volumes Workspace nodes.

2. Then, select Manage Review Volumes. This displays a box at the side of each volume as shown below. Volumes that are enabled are visible in SmartPlant Review.

   

3. After you have finished selecting the appropriate volumes, right-click on the Project Volumes/Volumes Workspace node and select Manage Review Volumes again to finalize the selection. The selected volumes are then displayed in the Point Cloud Manager Add-in within SmartPlant Review.

Display set volume selection

This mode makes volume selections based on Display Sets, allowing volume around a pipe run, and so on, to be taken.

Display sets must be in a folder to be added to the volumes list.