Adjust volume

After the volume has been created, selecting the button shown below brings back the blue box around the current volume.

This enables you to modify the current volume using the blue, arrow grips on each side and corner of the box, or to translate/rotate the current volume through the Translate/Rotate icon as shown in section Get Volume At Point. Again, press Enter or right-click to accept the volume. The Volume Selection dialogue appears and can be used as per the initial volume selection.

Volume adjustment in Orthographic mode

After the initial volume has been processed, you can resize or move the volume using the Adjust button.

Select the Adjust button to display the light blue arrows within the current volume as shown in the image below:

Hovering over any of the arrows will highlight the potential direction for modification of the current volume. The box can be resized on one side by selecting and dragging the arrow on the appropriate side. The entire box can also be resized by selecting and dragging one of the four corner arrows. The entire box can also be moved by selecting the Translate/Rotate icon at the bottom right of the 3D window and dragging any of the lines or arcs on the modification frame as described above.

When you are happy with the size and location of the box, press Enter or right-click inside the blue box to bring up the Volume Selection dialogue again. Make any necessary changes and select OK to accept and process the volume.

Only points from scans where the points and BubbleViews are loaded will be displayed inside the selected volume.