Raw reason code validation error messages

Whenever the UCO is saved in Object Editor, a validation of the raw reason codes is performed. This validation is performed on the syntax of all expressions and the existence of the default utilization reason group and reason. The validation takes approximately 5 seconds for 1000 raw reason codes. In addition, expression reference validation is performed for instances (not for templates) when the Object Editor is closed.

If any errors are found, they appear in the error message area above the attribute settings on the General tab. These errors must be resolved for the object to be deployed and used at run time. For object instances, raw reason code errors can be reported for the object regardless of whether the raw reason code is unique to the object or derived from a template.

The error message list behavior is as follows:

• If there is more than one error, you can scroll through the messages using the up and down arrows. The raw reason code corresponding to the current error message is automatically selected. However, note that selecting a raw reason code does not cause its error messages to be selected. You have to use the error message up and down arrows to navigate to its error messages.

• Scroll controls will appear for long error messages.

• If the raw reason code name is too long to fit in the error message header area, you can hover over the name to see the full name in a tool tip.

• If you correct an error, the error messages are not automatically cleared or updated. You must perform a Save, or Save/Close/Reopen for expression reference errors in an instance, to refresh the error message list.