Configure the Sample Viewer control

When you use the Sample Viewer control in a System Platform symbol, you can link it with a Button Bar control. For more information, see Associate the Button Bar control with other controls.

In addition to viewing the current, past, and future samples, an operator can perform the following tasks using the buttons in the button bar, listed by buttons from left to right:

• Edit a sample's lot number, sublot number, segment requirement ID, segment response ID, or priority.

• Specify that a sample has been pulled.

• Specify that a sample that had been previously pulled but for which no results were entered is no longer considered to be pulled.

• Indicate whether a sample is considered to be finalized.

• Enter new results or edit previously entered results for the characteristics that are associated with a current or past sample.

• Launch the SPC Chart control to display the results of measurements taken for a particular characteristic.

• Cancel a sample (this button is not shown above, as it is not included on the button bar by default)

• Filter the set of samples displayed.

• Open the MES online help, which includes MES Operator help topics.

• Refresh the Sample Viewer control contents.