TCP/IP Hosts - Communication Settings
- Last UpdatedNov 01, 2021
- 1 minute read
To establish communication with a device, configure the associated Boards, Ports and I/O Device in Plant SCADA Studio's Topology activity. If you use the Express Communications Wizard to connect to a device, these settings will be automatically configured for you. However, if you need to manually configure these settings, use the information outlined below.
Board Settings
|
Field |
Value |
|---|---|
|
Board Type |
Enter CTICMP. |
|
Address |
Enter 0. |
|
I/O Port |
Leave this field blank. |
|
Interrupt |
Leave this field blank. |
|
Special Options |
Leave this field blank. |
Port Settings
A port definition is required, however some fields can be left blank. Only the port name, port number and board name are required. Only one port maybe specified for the CTICMP driver.
|
Field |
Value |
|---|---|
|
Port Number |
Leave this field blank. |
|
Baud Rate |
Leave this field blank. |
|
Data Bits |
Leave this field blank. |
|
Stop Bits |
Leave this field blank. |
|
Parity |
Leave this field blank. |
|
Special Options |
Leave this field blank. |
I/O Device Settings
|
Field |
Value |
|---|---|
|
I/O Device Name |
Enter a unique name (different to other IO device names with the same port name). This value could be blank if only one IO device exists. |
|
I/O Device Protocol |
Enter CTICMP. |
|
I/O Device Address |
Leave this field blank. |