Software Setup
- Last UpdatedSep 02, 2022
- 1 minute read
Each PCD will need to be set up with the right communication configuration. SAIA provides configuration programs (such as PG3 or PG4) to configure the desired protocol, baud rate, timeout, and so on.
The Run indicator displayed on the front panel of the PCD indicates whether there is a program loaded into the CPU of the unit. A running program is not required for the unit to function, however, any specific register (such as the LCD display register) may not be accessible without the use of a proper configuration program.
To select SBUS - Data Mode, you need to have the following firmware and software that supports it:
|
SAIA Program |
Firmware Version |
|
PCD1 Firmware |
From V 002 |
|
PCD2 Firmware |
From V 005 |
|
PCD4.xx5 Firmware |
From V 00D |
|
PCD6.M3 Firmware |
From V 001 |
|
PG3 |
From V 2.1 |
|
PG4 |
From V 1.4 |
|
SCOMM-DLL 32 bit |
From V $114 |
|
S-Bus Analyser |
From V $ 007 |