Generic Devices - Hardware Setup

Set your PLC to the communication setting you want. The default hardware settings for the device are as follows:

Note: These settings are recommendations only. If you use the Communications Express Wizard, these default settings are configured in your project automatically, though your hardware may support other values. If you do set the baud rate, data bits, stop bits or parity to another value, you must manually set the new value(s) in your project.

Set the following configuration options on the Modbus port on the PLC:

• Station number

• RTU mode (This is not selected if the MODBUSA protocol is being used)

• Delay time to 1