Specific Parameters
- Last UpdatedMar 06, 2024
- 1 minute read
|
|
|
UNINTENDED EQUIPMENT OPERATION Do not change these protocol parameters, except on the advice of Technical Support for this product. Failure to follow these instructions can result in death, serious injury, or equipment damage. |
Note: Always seek the advice of Technical Support personnel for this product regarding undocumented features.
The following table describes the driver-specific Citect.ini parameters.
|
[ABLMXEIP] Parameter |
Allowable Values |
Default Value |
Description |
|
ENIOnlyMode |
1 - enabled 0 - disabled |
0 |
This parameter enables a communication method that works exclusively with an ENI Ethernet/IP module. It does not support communication with the built-in port on a MicroLogix 1100. You should only enable this parameter if you are experiencing difficulties communicating with a device (other than an MicroLogix 1100) via an Ethernet/IP module. |