[MultiMonitors]StartupPage<Name>
- Last UpdatedJul 19, 2023
- 1 minute read
Determines the page that appears on the monitor that corresponds to the screen named "Screen1" in the screen profile.
On start up, Plant SCADA will compare the physical monitors on the workstation to the screens in the screen profile and attempt to map screens to monitors based on the resolution and relative position to the primary monitor/screen. If a physical monitor cannot be found, for example it has failed or been disconnected or the configuration is incorrect, that screen will be mapped to the primary monitor. So, you may have multiple pages displayed on the primary monitor.
Note: If you don't specify a startup page for a monitor in the Setup wizard, any startup page setting in the Citect.ini file will be replaced by ><. This overrides the configuration of a monitor set up with a page in the Parameters database.
Allowable Values:
Any valid page name
Default Value:
No default. However, if no value has been specified for any of the screens, the page specified by the [Page]Startup parameter will be shown on the primary screen only.