Add physical elevation

Physical elevation

If the Physical elevation text box is shown, this means, that for this installation front-to-vertical projection can be made.

If this is the case, you should define the physical elevation for projection on the destination plot plan. Elevation is given in meters.

Logical elevation

Also, logical elevation should be defined to allow for correct transformation.

Ensure altitude checkbox is active

To use elevation in plot plans, you will need to select the Work position on plot plan requires altitude checkbox on Site parameters. This should be done before adding plot plans.

Setting physical elevation

Elevation can be set on destination image, by pressing CTRL key with right mouse button.

To add elevation to Plot Plan images

1. Set mouse on initial position, press the CTRL key and right mouse button, then move the mouse while keeping CTRL key and the right mouse button pressed.

2. At the position of elevation, release the right mouse button. The Elevation level will be plotted as a blue shaded area.

   

Fine tune the height

Use the OSM Administration interface to easily fine tune the logical height value. See Adjust Projection / Cross Section.