Label Pipe Destination Fittings

The procedure can be used to label pipe destination fittings.

For details of the use of this procedure in the context of drawing P&IDs, refer to Label Pipe Destination Fittings.

Procedure

1. Start the procedure by either:

   • selecting the symbol to be labelled on The Drawing Page, then selecting Properties from the shortcut menu, or

   • selecting the Properties option in the Properties group of the Home tab.

     Note: Labels can also be viewed using the Non-Modal Properties Dialog, but tags cannot be directly entered into this dialog. Other details can be entered or changed however, and the drawing labelled with them.

2. If the first method of starting the procedure is followed, the AVEVA P&ID Line Fittings Properties dialog for the symbol is then displayed.

   If the other method is followed, the Command prompt will display:

   Select Item to Label, or Label to Modify:

   Pick the item to be labelled.

3. The AVEVA P&ID Line Fittings Properties dialog is then displayed:

   

   Enter the size, specification, Prefix, Type, Number and Suffix of the fitting as required.

   Select YES in the Inheritance field if the item is to subject to attribute inheritance from the sheet or the owning pipe. The dialog displays read-only attributes of the owning pipe.

   Click OK.

4. The Command prompt will display:

   Position Label:

   Place the label near or on the item.

5. The Command prompt will display:

   Select Item to Label, or Label to Modify:

   Pick another item to continue labelling, or press or select Enter to end the command.