Change the Owning Pipes of Branches

This procedure is used to change which pipe is the owner of a branch.

Procedure

1. Start the procedure by either:

   • selecting the Change Pipe Owner option in the Modify group of the Home tab, or

   • selecting the pipe on The Drawing Page, selecting the Change Pipe Owner option in the Modify group of the Home tab.

2. If the first method of starting the procedure is selected, the Command prompt will display:

   Pick a branch pipe to change its owner pipe:

   Note: The branch must be selected, not its label.

   This step is omitted if the second method of starting the procedure is selected, as the branch will already have been selected.

   Select the branch that is to be allocated to another pipe.

3. The Command prompt will display:

   Indicate owner pipe for branch, or Trim for Trim pipe (<ret for new pipe>):

   Select the main pipe that is to be owner of the branch.

   The ownership of the branch is then switched to the selected pipe.