Exchange Symbols Globally

This procedure is used to exchange similar types of AVEVA P&ID symbols on a drawing.

Mappings are set up in the AVEVA P&ID Project Administration program in which symbol types are mapped to the symbol types they are to be exchanged for. When the procedure is implemented, symbols are exchanged in accordance with these mappings.

Multiple symbol types can be exchanged at the same time using this method.

This procedure can be used to swap symbols provided that the two symbol item types are the same. It is not possible to swap one P&ID type for another, e.g.: Valves for Equipment. If any item types do not match, an error will be displayed, listing the mismatches, and the old symbols are left in place. If problems are encountered, an AVEVA P&ID error balloon appears.

Refer to Exchange Individual Symbols.

Note: Valves and reducer symbols may be restricted so that they can only be inserted into pipes with specific codes and sizes. These are specified using the Spec Driven Configuration Category of the AVEVA P&ID Project Administration program. When a symbol is exchanged, the system checks that the symbol selected to replace the old symbol is valid for the code and size of the pipe. If it is not, the exchange may be prevented, or a warning displayed, depending on the project setup.

Note: Line Termination (LTS) symbols cannot be exchanged.

Associated Project Configuration Options

Symbol mappings are specified in the Symbol Exchange list in the List of Values Configuration Category of the AVEVA P&ID Project Administration program.

Procedure

Start the procedure by selecting the Global Symbol Exchange option in the Symbol group of the Home tab.

AVEVA P&ID then performs a Zoom All. The symbols change dynamically on the drawing as the exchange proceeds in accordance with the mappings.