Output Voltages Tab (Loads Assigned Tab - MCCs and Switchboards)

Loads fed by MCC and Switchboard busbars must have a voltage matching one of the supply output voltages listed on this tab. The default output voltages are displayed below.

To add another voltage to the busbar, click Add. The Select Voltage window is displayed:

The window lists the pre-defined list of project voltages (refer to Project Voltages for further information). Click on the required voltage and click OK to add it to the list in the Output Voltages tab.

To remove an output voltage, select it in the tab and click Remove. A message will then be displayed requesting that the deletion be confirmed. Click Yes to continue.

If the voltage is the only one listed in the tab, it cannot be deleted (the busbar must have at least one output voltage). A message will be displayed to inform the user of this and the deletion will be cancelled.

A supply voltage cannot be deleted either if it is in use by a fed item. A message will be displayed to inform the user of this and the deletion will be cancelled.