Wire Numbering

Electrical Wiring Manager supports two methods of wire numbering:

1. Signal Numbers - wire numbers are based on a 'source' signal.

2. Ferrule Numbers - wire numbers are different at each wire or end of each wire.

Both these methods can be used in a single Electrical Wiring Manager project. However when both are used, Ferrule Numbers always override Signal Numbers when Electrical Wiring Manager creates termination reports or Termination Diagram drawings (in AutoCAD using Electrical Designer). So any Signal Number is always ignored in documents and reports if a Ferrule Number exists at a specific wire end. This enables users to override Signals if required in documents.