View Options

The following facilities are located at the bottom of the window:

• To zoom in and out use the Scale slider, the plus and minus buttons, or hold down the Ctrl key and move the mouse wheel up (to zoom in) or down (to zoom out).

• If panning is enabled by clicking the Enable Panning button (it is off by default), the diagram can be navigated around by left-clicking and dragging the mouse in the required direction.

• Click Scale to Fit to zoom out or in so that contents of the diagram fit the window.

• If the window is in cable mode, toggled by clicking the Cable Mode button, cable details can be viewed and edited. See Create Content of Key One Line Diagrams. Applicable to Key One Line diagrams only.

• To display a small window in the bottom-right corner of the main window displaying an overview of the diagram, click Overview. For example:

  

  Click the button again to close the overview.

• Click on a symbol or cable on the drawing to center the main window on that drawing element.