Fillet Section

Merges two non parallel, coplanar sections and applies a curved fillet, regardless of specification, justification or beta angle.

If the sections are parallel, or not coplanar, a Warning message displays on the status bar.

The properties of the merged sections and fillet are inherited from the first picked section.

1. You are prompted to Pick first Section end to fillet

2. Click to identify the first section end to apply a fillet to.

3. You are then prompted to Pick second Section end to fillet.

4. Click to identify the second section end to apply a fillet to.

5. You are then prompted to Fillet radius (R = #) or <Finish>.

6. Input a dimensional value in the field and press Enter to define the radius of the fillet. The default is 1000mm.

7. Input F at the prompt and press Enter to end the command. The sections are merged and a fillet is created.

8. Throughout the fillet process you can press ESC to cancel the command. Additional functionality is also available.

   Finish	Press the down arrow key and select Finish to end the command.