Create Disc Negative Extrusion with Two Specified Points

Creates a disc negative extrusion with two specified points.

1. You are prompted to Select panel

   Note: The prompt does not display if the panel is already selected.

2. Click to identify the panel using a cursor pick in the 3D view.

3. You are then prompted to Start diameter point (Surface: #, Depth: #mm) or.

4. Input values in the dimension fields and press Enter or click to identify the start diameter point position.

5. You are then prompted to End Diameter Point (Surface: #, Depth: #mm) or.

6. Input a dimensional value in the field and press Enter or click to identify the diameter of the disc negative extrusion. A disc negative extrusion is created and displays in the 3D view.

7. Throughout the panel creation process you can press ESC to cancel the command. Additional functionality is also available.

   Centre+	Press the down arrow key and select Centre+ to create a disc negative extrusion with a specified centre point. Refer to Create Disc Negative Extrusion with Specified Centre Point for further information.
   Three point	Press the down arrow key and select Three point to create a disc negative extrusion with three specified points. Refer to Create Disc Negative Extrusion with Three Specified Points for further information.
   Depth	Press the down arrow key and select Depth to define the depth of the negative extrusion. You are prompted to Specify the Depth <#> The default depth value is identical to the associated panel thickness. Input a dimensional value in the field and press Enter to set the depth of the negative extrusion.
   Surface	Press the down arrow key and select Surface to define the surface position of the negative extrusion. Input a justification value in the field and press Enter or press the down arrow key and select a justification value.
   Back	Press the down arrow key and select Back to undo the last action.
   Top	Press the down arrow key and select Top to create a negative extrusion aligned to the top of the associated panel.
   Bottom	Press the down arrow key and select Bottom to create a negative extrusion aligned to the bottom of the associated panel.

The new PLOO and PAVE elements display in the Model Explorer.

Refer to Non-Routed Item for further information.