Please ensure Javascript is enabled for purposes of website accessibility
Powered by Zoomin Software. For more details please contactZoomin

Everything E3D

TABLE OF CONTENTS

‘A’ Plane Splitter (CR)

Save PDF
Save selected topicSave selected topic and subtopicsSave all topics
Share
Share to emailCopy topic URL
  • Last UpdatedMay 20, 2026
  • 2 minute read

The task of creating an HVAC Component is initiated from the HVAC Window.

  1. Select Rectangular in the Categories drop-down list and then ‘A’ Plane Splitter in the Available Type drop-down list to display the ‘A’Plane Splitter window:

  2. You are required to input the following dimensions:

    • Duct Width AA

    • Duct Depth AB

    • Duct Width LA

    • Duct Depth LB

    • Length

    • A Offset

    • B Offset

    • Arrive Extension

    • Leave Extension

    • Splitter F Offset

    • Splitter L Offset

  3. To visualize how the dimensions equate to the actual piece of HVAC click Picture to display a detailed drawing for ‘A’ Plane Splitter (CAR).

    Note: The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalogue.

  4. Click Transpose Width/Depth to exchange Duct Width AA dimension with Duct Width AB dimension or to exchange Duct Width LA dimension with Duct Width LB dimension.

  5. Specify a type of joint to use for the Arrive Joint and Leave Joint. Refer to Create/Modify HVAC Component for a detailed description.

  6. After selecting the type of joint for the Arrive Joint and Leave Joint you must enter the A Offset Direction.

  7. In A Offset Direction enter the direction for the A Offset relative to the Point of Origin. Valid directions are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).X, Y, Z, -X, -Y or -Z.

  8. In the Position list, select Connect or Unchanged:

    • Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

    • Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

      Note: Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

  9. Click Defaults to reset all the fields back to when the ‘A’ Plane Splitter window was opened.

  10. Click Fit to orientate the ‘A’ Plane Splitter to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

  11. Click OK to create the ‘A’ Plane Splitter component and close the ‘A’ Plane Splitter Window. You will be returned to the HVAC Window.

  12. Click Cancel to discard all field changes and close the ‘A’ Plane Splitter window.