Please ensure Javascript is enabled for purposes of website accessibility
Powered by Zoomin Software. For more details please contactZoomin

Everything E3D

TABLE OF CONTENTS

Rectangular Motorised Damper r (CIPE)

Save PDF
Save selected topicSave selected topic and subtopicsSave all topics
Share
Share to emailCopy topic URL
  • Last UpdatedMay 22, 2026
  • 2 minute read

The task of creating an HVAC Component is initiated from the HVAC Window.

  1. Select Inline Plant Equipment in the Categories drop-down list and then RECTANGULAR, Motorized Damper in the Available Type drop-down list to display the Motorized Damper window:

  2. You are required to input the following dimensions:

    • MVCD Name(Ref)

    • Duct Width AA

    • Duct Depth AB

    • Length

    • Spindle Direction

  3. To visualize how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Rectangular Motorised Damper (CAIPE).

    Note: The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalogue.

  4. Click Transpose Width/Depth to exchange Duct Width AA dimension with the Duct Width AB dimension.

  5. Specify a type of joint to use for the Arrive Joint and Leave Joint. Refer to Create/Modify HVAC Component for a detailed description.

  6. After selecting the type of joint to use for the Arrive Joint and Leave Joint you must enter the Spindle Direction.

  7. In the Spindle Direction specify the axis that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).X, Y, Z, -X, -Y or -Z.

  8. The Clash Vol fields will be pre-populated with the obstruction volumes associated with the rectangular flanged FD component and the ducting, but can be changed by you.

  9. In the Position list, select Connect or Unchanged:

    • Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

    • Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

      Note: Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

  10. Click Defaults to reset all the fields back to when the Motorised Damper window was opened.

  11. Click Fit to orientate the Motorised Damper to automatically match the outlet (p-leave) of the previous piece of HVAC to the inlet (p-arrive) of the next piece.

  12. Click OK to create the Motorised Damper component and close the Motorised Damper Window. You will be returned to the HVAC Window.

  13. Click Cancel to discard all the field changes and close the Motorised Damper window.