Snapshots for the AA3 example simulation

This simulation includes the following snapshots:

• FF 1 loads the steady-state condition. The valve setup matches the Production step for the PSA process.

• FF 2 loads the initial condition for Dynamics mode. The beds are full of helium.

• Dyn 1 loads the initial condition.

• Dyn 2 shows the final conditions after running the All Steps - the full Cycle scenario.

• Dyn 3 shows the final conditions after running the Run 5 Cycles scenario.

• Dyn 4 shows the final conditions after running the Run 10 Cycles scenario.

Load the initial steady-state conditions

1. Switch to Fluid Flow mode.

2. Revert the simulation to the FF 2 snapshot.

3. Switch back to Dynamics mode.

4. Change the source composition from 100% helium to the air condition (21% O2, 78% N2, and 1% Ar).