Snapshots for the AA4 example simulation

This simulation includes the following snapshots:

FF 1 loads the steady-state condition. The valve setup matches the first step in the PSA process, where Bed 1 produces and Bed 2 vents.

FF 2 loads the initial condition for Dynamics mode. Both beds are full of oxygen.

Dyn 1 loads the initial condition.

Dyn 2 shows the final conditions after running the All Steps - the full Cycle scenario.

Dyn 3 shows the final conditions after running the Run 5 Cycles scenario.

Dyn 4 shows the final conditions after running the Run 10 Cycles scenario.

Load the initial steady-state conditions

1. Switch to Fluid Flow mode.

2. Revert the simulation to the FF 2 snapshot.

3. Switch back to Dynamics mode.