Manual meter tab

A manual meter is a meter where the actual metering technology is irrelevant. The data, typically volumetric, is entered either manually or through an automatic file loader.

To configure the properties for meter - manual meter

1. Select the Manual Meter tab.

   Note: In order to see the Manual Meter tab, you must have defined a Metering method of Manual meter.

   

2. Select your desired Data Source:

   • In-house meter

   • Third Party meter

   • Third Party meter — supplemental

   • Line Pack meter

   • Gas Loss meter

   • SCADA

   • Steam meter

   • Liquid Mass

     Note: For Liquid Mass meters, the volume will be calculated from the mass using API 14.4 mass to volume calculation if it is configured to do so.

   • Blowdown meter

   • Manual Host Calculated

   • Sulphur meter — No measurement or validation data is required.

3. Enter the Saturated HV Correction Factor.

   This is the Water Vapour Correction Factor (WVCF) to use on third party entries when converting heating values from dry to saturated. The minimum value available for for entry is 0, and the maximum entry is 10,000.