View meter data and manually calculate the station balance

To view the meter data and manually calculate the station balance

1. In the User Options, set the viewing Precision Profile to the same profile configured as the Balance Precision Profile for the station.

   

2. Open the Meter Data Editor for each meter that is connected to the station.

3. Set the date range for each meter so that the date range is the same as the station balance that is being calculated.

4. In the Meter Data Editor, view the data for each meter that contributes to the balance of your station.

   

   Add the Rounded Original Total values from each meter contributing to the station, accounting for the configured amount of contribution (for example, 1 versus 0.5). This total value should equal the station balance. This assumes that the station balance calculation was also configured for Round then Sum.

   Note: Round then Sum is the only Rounding Rule supported by the Meter Data Editor.