Control the Precision of Generated Output​.​.​.

PCODE LINEAR [MM | CM | METRES] TO integer DPLS

set linear (metric) precision to integer decimal places for either mm, metres or cms (only one of these is supported per PCODE, the other two values are derived from this one)

PCODE LINEAR INCHES TO integer

DPLS

set linear (Imperial) precision to integer decimal places

PCODE LINEAR FRACTIONS TO

integer [THS | NDS]

set linear (fractional, Imperial) precision to integer 32ths (or 32nds)

PCODE ANGLES TO integer [DPLS

| DEGREES | MINUTES | SECONDS]

set angular precision to integer decimal places (or degrees, or minutes, or seconds).

PCODE TRAILING ZEROS [ON | OFF]

Switch trailing zeros after the decimal point on or off.

Q PCODM

query metric precision (either mm, cm or metres)

Q PCODInches

query Imperial (inch) precision

Q PCODFractions

query fraction precision

Q PCODAngles

query angle precision