TRAP Symbol Keys
- Last UpdatedAug 19, 2025
- 2 minute read
|
Component Description |
SKEY |
Plotted Symbol |
P-points |
Note |
|---|---|---|---|---|
|
Trap - In Line (Straight Through) |
TI** |
|
|
2 |
|
Trap - Angle |
TA** |
|
|
1,2 |
|
Trap - Offset |
TO** |
|
|
1,3 |
|
Trap - Return |
TR** |
|
|
1,4 |
Note:
|
1 |
Replace the ** characters in the symbol key with one of the following end condition identifiers: BW for butt weld CP for compression SW for socket weld FL for flanged SC for screwed PL for plain |
|
2 |
To use this symbol, the p-points must be arranged as shown in the following diagram:
|
|
3 |
To use this symbol, the p-points must be arranged as shown in the following diagram:
P3 must not have a valid bore. It is used only to obtain correct orientation of the element. P3 can be orientated in Paragon. Note: The horizontal offset may be zero; that is, P0, P1, P2, and P3 may be coplanar. |
|
4 |
To use this symbol, the p-points must be arranged as shown in the following diagram:
Note: The horizontal offset may be zero; that is, P0 and P1 (and similarly P2 and P3) may be coincident. |
