Create Disc Panel with Specified Centre Point
- Last UpdatedMay 05, 2023
- 2 minute read
Creates a disc panel with a specified centre point.
You are prompted to Centre point or
Input values in the dimension fields and press Enter or click to identify the centre point position.
You are then prompted to Diameter (Thk: #mm, Just: #) or <Radius>
Input a dimensional value in the field and press Enter or click to identify the diameter of the disc panel. A disc panel is created and displays in the 3D view.
Throughout the section creation process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Three point |
Press the down arrow key and select Three point to create a disc panel with three specified points. Refer to Create Disc Panel with Three Specified Points for further information. |
|
Two point |
Press the down arrow key and select Two point to create a disc panel with two specified points. Refer to Create Disc Panel with Two Specified Points for further information. |
|
Radius |
Press the down arrow key and select Radius to create a disc panel with a fixed radius. You are prompted to Radius (Thk: #mm, Just: #) or <Diameter> Input a dimensional value in the field and press Enter to set the radii of the disc panel. |
|
Justification |
Press the down arrow key and select Justification to define the justification position of the panel. Input a justification value in the field and press Enter or press the down arrow key and select a justification value. |
|
Back |
Press the down arrow key and select Back to undo the last action. |
|
Diameter |
Press the down arrow key and select Diameter to create a disc panel with a fixed diameter. You are prompted to Diameter (Thk: #mm, Just: #) or <Radius> Input a dimensional value in the field and press Enter to set the diameter of the disc panel. |
|
Top |
Press the down arrow key and select Top to create a panel with top justification. |
|
Bottom |
Press the down arrow key and select Bottom to create a panel with bottom justification. |
|
Centre |
Press the down arrow key and select Centre to create a panel with centre justification. |
The new PANE displays in the Model Explorer.
Refer to Non-Routed Item for further information.