Flat Oval ‘A’ Boot f

The task of creating an HVAC Component is initiated from the HVAC Window.

Select Branch Connectors in the Categories drop-down list and then FLAT OVAL, ‘A’ Boot f in the Available Type drop-down list to display the Oval ‘A’Boot Brco window:

You are required to input the following dimensions:

• Boot Width

• Boot Depth

• MAIN Width LA

• MAIN Depth LB

• Boot Length

• Distance From Leave

• B offset

• Boot Extension

• Fixing to Duct

• Male Collar

• Inner Extension

To visualize how the dimensions equate to the actual piece of HVAC, click Picture to display a detailed drawing for Flat Oval ‘A’ Boot.

Note:
The fields will be pre-populated with default dimensions. These dimensions are governed by the details defined in the HVAC Catalog. The Boot Extension default is auto but can be changed by you to a required dimension. The Fixing to Duct joint default is joint defined in the HVAC Catalog but can be changed by you to the required joint.

Click Transpose Width/Depth to exchange Boot Width dimension with Boot Depth dimension or to exchange MAIN Width LA dimension with MAIN Depth LB dimension.

Specify a type of joint to use for the Boot Joint. Refer to Create/Modify HVAC Component for a detailed description.

After selecting the type of joint to use for the Boot Joint, you must enter the Boot Direction.

In Boot Direction specify axis that should be used. Valid axes are E (East), N (North), U (Up), -E (negative East), -N (negative North) or -U (Negative Up).

In the Position list, select Connect or Unchanged:

• Click Connect (default when Create is selected) - connects the piece of HVAC to the previous one.

• Click Unchanged (default when Modify is selected) - positions the component at the co-ordinates 0.00.

  Note:
  Unchanged is usually used, when Modify is selected, it does not connect the component but positions it at 0.00, in effect in a floating position.

Click Defaults to reset all the fields back to when the Oval ‘A’Boot Brconnector window was opened.

Click Fit To Next to orientate the Oval ‘A’ Boot Branch Connector to automatically fit this piece of HVAC to the next piece.

Click OK to create the Oval ‘A’ Boot Branch Connector component and close the Oval ‘A’Boot Brconnector Window. You will be returned to the Create/Modify HVAC Component.

Click Cancel to discard all field changes and close the Oval ‘A’Boot Brconnector window.