Standard Pattern
- Last UpdatedAug 13, 2025
- 1 minute read
IsoADP has the ability to place a standard pattern on each drawing and is accomplished by the creation of an overlay (OVER) at the sheet. A simple example is supplied, which can be modified as required.
The example OVER /TT/Isometric-StanPat contains two layers;
-
Attribute Purpose set to HVAC.
-
Attribute Purpose set to CWAY.
The overlay is positioned by the backing sheet reserved area …/StanPatArea.
The layer matches the type of drawing being created either HVAC or CWAY, hence it is important that the layers use these words for the attribute purpose if they are to be controlled in this manner.