Change filter names

To change the default filter names, which is necessary in order to achieve language localization, open the auditorplus.global.config file (see Localization and site customization) in an XML editor.

There are three sections of this file that require modification to change the report names. The screenshot on the left in each example below shows the filter displayed in Auditor Plus; on the right, the associated XML.

1. Locate the section titled "<FILTEROPTIONS> under "<COMPLETE>" as shown in the example below.

   

2. Change the reports’ "TITLE" data (shown highlighted in the example above), to the text that you wish displayed within the application.

3. Next, locate the section titled "<FILTEROPTIONS>" under "<Sched>" as shown in the example below.

   

4. Change the reports’ "TITLE" data (shown highlighted in the example above), to the text that you wish displayed within the application.

5. Finally, locate the section titled "<FILTEROPTIONS>" under "<SchedOrComplete>" as shown in the example below.

   

6. Change the reports’ "TITLE" data (shown highlighted in the example above), to the text that you wish displayed within the application.

7. Save the file under its original filename.