Material Quality specification limit properties
- Last UpdatedSep 10, 2023
- 1 minute read
Refer to the following tables for the key configurable properties of the Material Quality specification limit.
Behavior properties
|
Property |
Description |
Valid values |
|---|---|---|
|
DataType |
(Required) The data type for the item. This is an important value for storing and aggregating data correctly. The correct data type is critical to the ability of Production Analyst to display and aggregate information in fields. |
Integer, Single, Double, Long. |
Specification properties
Note: When you configure lower and upper expressions, check that the result of the Upper Expression, as shown in UpperValues, is of greater value than the result of the Lower Expression, as shown in LowerValues, at all times. No automatic validation is performed to verify that this is the case. If you configure invalid values, the samples may be out of specification.
|
Property |
Description |
Valid values |
|---|---|---|
|
LowerExpression |
The lower limit value of the specification against which to check the sample data. Use the Expression Editor to build the expression that defines the lower value of the specification limit. The value is out-of-specification whenever it falls below this level. |
Expression |
|
UpperExpression |
The upper limit value of the specification against which to check the sample data. Use the Expression Editor to build the expression that defines the upper value of the specification limit. The value is out-of-specification whenever it is higher than this level. |
Expression |