Change Length with Specified Percentage
- Last UpdatedApr 08, 2024
- 2 minute read
Sets the length of an object using a specified percentage.
The prompt Select object to change or is displayed.
Input P at the prompt or press the down arrow and select Percent.
The prompt Enter percentage length <#> is displayed.
Input a percentage value in the field and press Enter to increase or decrease the object length. A value below 100 decreases the object length, a value above 100 increases the object length.
The prompt Select object to change or is displayed.
Click to identify the object to change. The object length is modified at the end nearest to the selection point.
The prompt Select object to change or <Finish> is displayed.
The prompt is repeated, multiple objects can be lengthened.
Input F at the prompt and press Enter to end the command.
Press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Delta |
Changes the length of objects with a specified delta length. Refer to Change Length with Specified Delta Length for further information. |
|
Percent |
Changes the length of objects with a specified percentage. |
|
Total |
Changes the length of objects with a specified total length. Refer to Change Length with Specified Total Length for further information. |
|
Dynamic |
Changes the length of objects dynamically. Refer to Change Length Dynamically for further information. |
|
Length |
Displays the length of the currently selected object on the status bar. |
|
Back |
Undoes the last action |
|
Finish |
Ends the command. |
