Component Orientation
- Last UpdatedFeb 19, 2025
- 2 minute read
Keywords
ORIENTATE
Description
This command rotates the Component about its origin so that (in forwards mode) the Arrive p-point is in the opposite direction to the previous Component’s Leave p-point.
If the Component is not concentric, it is necessary to specify the off-line orientation as well. This is usually done by giving the direction of an off-line p-point. If it is not possible to achieve an orientation because of the direction of the constrained centerline, MODEL will leave this off-line direction in the closest orientation to that requested.
Examples |
|
|---|---|
|
ORI |
Rotate the current element about its origin so that (in forwards mode) its Arrive Point is in the opposite direction to the previous Component’s Leave Point (refer to the Orienting a Concentric Component image). |
|
ORI AND P3 IS U |
As above, and orient the off-line p-point (P3) in the specified direction (refer to the Orienting a non-concentric Component by means of an off-line p-point image). |
Note:
The ORIENTATE command will not change the ANGLE, RADIUS etc. of a variable Component to accommodate an oblique off-line
direction.
Command Syntax
>- ORIentate -+- <bdir> IS <bdir> -.
| |
‘--------------------+- AND <bdir> IS <bdir> -.
| |
‘------------------------+-->
Querying
.-------------------<----------------.
/ |
>-- Query <marke> --*-- DIRection --. |
| | |
‘---------------+-- WRT --. |
| | |
|-- IN ---+-- <gid> --’
|
‘-->
Orienting a Concentric Component
Orienting a non-concentric Component by means of an off-line p-point