Splice Section at Panel Intersection
- Last UpdatedMay 05, 2023
- 2 minute read
Splices sections at a panel intersection.
You are prompted to Pick element(s) to splice
Note:
The prompt does not display if the section element is already selected.
Click to identify a section to splice.
You are then prompted to Pick element(s) to splice or <Next>
Note:
The prompt does not display if the section element is already selected.
The prompt is repeated, allowing you to identify multiple sections to splice.
Input N at the prompt and press Enter to specify the splice point.
You are then prompted to Pick panel to splice with or <Plane>
Click to identify an intersecting panel to define a splice point.
The sections are spliced at the intersecting panel points.
Throughout the splice process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Next |
Press the down arrow key and select Next to proceed to the next splice process. |
|
Plane |
Press the down arrow key and select Plane to splice a section using a plane. Refer to Splice Section using a Plane for further information. |
The new GENSEC elements display in the Model Explorer.
