Create Ring Panel with Two Specified Points
- Last UpdatedMay 05, 2023
- 2 minute read
Creates a ring panel with two specified points.
You are prompted to Start diameter point or
Input values in the dimension fields and press Enter or click to identify the first diameter point position.
You are then prompted to End diameter point (Thk: #mm, Just: #) or
Input a dimensional value in the field and press Enter or click to identify the diameter of the ring section.
You are then prompted to Panel width (Thk: #mm, Just: #) or
Input a dimensional value in the field and press Enter or click to identify the width of the ring panel. A ring panel is created and displays in the 3D view.
Throughout the panel creation process you can press ESC to cancel the command. Additional functionality is also available.
|
|
|
|
Centre+ |
Press the down arrow key and select Centre+ to create a ring panel with a specified centre point. Refer to Create Ring Panel with Specified Centre Point for further information. |
|
Three point |
Press the down arrow key and select Three point to create a ring panel with three specified points. Refer to Create Ring Panel with Three Specified Points for further information. |
|
Justification |
Press the down arrow key and select Justification to define the justification position of the panel. Input a justification value in the field and press Enter or press the down arrow key and select a justification value. |
|
Back |
Press the down arrow key and select Back to undo the last action. |
|
Top |
Press the down arrow key and select Top to create a panel with top justification. |
|
Bottom |
Press the down arrow key and select Bottom to create a panel with bottom justification. |
|
Centre |
Press the down arrow key and select Centre to create a panel with centre justification. |
The new PANE displays in the Model Explorer.
Refer to Non-Routed Item for further information.