Slope

Use the slope functionality to set the slope of a component’s leave tube (using the p-leave ppoint) whilst using quick pipe router by specifying the required rate of fall or slope angle. Applies only to a component which involves a change of direction (such as an elbow).

By default, No Slope is selected (no slope will be applied to the pipe leg). To set the sloping angle, select Slope Angle, the Set Slope Angle window is displayed.

Enter the sloping angle, click OK to apply the sloping angle, quick pipe router will route the pipe with the sloping angle or click Cancel to discard any inputs and close the window.

Note:
If the default slope is set on a pipe or branch then extra functionality is available for selection, Default Slope Up and Default Slope Down. When selected, quick pipe router would route the pipe in accordance with the selected default slope.