Create Mode
- Last UpdatedFeb 14, 2025
- 2 minute read
Use the Create Mode part of the Piping Component Editor window to set the direction of flow, the software creates the component in the Head to Tail direction by default.
|
|
Create components in the flow direction |
Creates the component in the Head to Tail direction. |
|
|
Create components against the flow direction |
Creates the component in the Tail to Head direction. |
If the Auto. Create check box is selected, the software automatically determines if there is a requirement for an associated component (on a valve, the associated component would be a flange and gasket) and if so, what is the appropriate.
If the Out of Spec check box is selected, an alternative specification component can be used.
If the Skip Connected Comps check box is selected, the pipework application automatically determines which components are connected, then positions the creation point approximately.